This is a great site. I placed my order and by the next am it was available for download. Had some problems with some missing copy on some pages. Once I brought the error to the OMC's attention, the issue was resolved. I'll come back again.
The quality of this manual is good. It has all schematics and setup information for both the MDS-B3 and the MDS-B4. The scan quality is quite good, all pages are readable, This service manual also contains scans of the operating instructions from the User manual.
Das Service Manual war von der ersten bis zur letzten Seite sehr informativ und hilfreich. Die Darstellung aller Teile war klar und der Text gut lesbar.
Vielen Dank, das war nicht der letzte Download bei ownner-manuals.com.
Text excerpt from page 32 (click to view)
NO WATER SUPPLY
Is the water supply shut-off?
NO
Is the tap opened?
NO YES
Open the tap.
When you press both Wash button and Rinse buttons simultaneously, is the water level frequency below 40? NO Is the inlet valve filter clogged with impurity?
YES
Check the chamber (Air) and the tube clogged with impurity.
YES
Clean the filter.
NO
Is resistance of the inlet valve connector k? between 2 to 8
NO
Replace the inlet valve.
YES
Check the voltage between each terminal of inlet Valve is 220~240V. (Refer to 7-2 TEST MODE) Replace PWB assembly (Main).
NO
DETERGENT DOES NOT FLOW IN
Is water supplied?
NO YES
Refer to solution NO INLET
Wiring diagram
Are replaceptacles correctly connected to the terminals of inlet valve?
NO
Check the wiring on the dispenser. Put the detergent in the correct position
YES
SOFTENER MAIN PRE WASH WASH
Is detergent put in the correct compartment of the drawer?
